REVERB TYPE: These controls select the reverb to be used. SOLO: Lets you monitor either wet or dry signals without altering the blend of the two. WET: Adjusts the amount of reverberated signal being output. Only available when used w/ both mics.ĭRY: Adjusts the amount of un-processed signal being output. WIDTH: Adjusts the stereo image of the reverb. MIC: Controls which microphones are active (left, right, or both). LPF: Adjusts the cut-off frequency of the low-pass filter. HI: Adjusts the gain of the high shelf filter, set at 5 kHz. LOW: Adjusts the gain of the low shelf filter, set at 200 Hz. HPF: Adjusts the cut-off frequency of the high-pass filter. PRE DELAY: The amount of time between the initial input signal and the reverberation.ĭECAY: Adjusts the length of the reverb tail. INPUT: Adjusts the gain of the incoming signal.
